Closed through mid December for relocation! Staymag™ magnet orders are likely to open much sooner than mid December.

Everflex™ is a USA made spring temper flex plate that is available in two options:

• Blank, uncoated plate with no build surface applied. We recommend this option if you want to experiment with other build surfaces, such as Garolite, Kapton, etc.
• Double-sided, textured, powder coated PEI plate made with genuine Sabic Ultem™ Polyetherimide powder. We recommend this option if you want a hassle-free 3D printing experience and a textured finish on the first layer of your prints.

Be sure to also order a Staymag™ magnet sheet so that you have the correct amount of holding force compared to other competitors.

When a print completes and cools down to a safe temperature, simply take the plate off and flex either side of it to release the print with ease; there is no risk of injuring the part or yourself!

Blank plates are 0.5mm thick while textured, powder coated PEI plates are ~0.75mm thick.

Note for cartesian plates: the first dimension listed corresponds to the width of the plate and is referred to as the 'finger tab side' dimension by us. The finger tab side should correspond to the front-facing view of your printer.

Please make sure you select the proper size when ordering! The sizes listed are the physical dimensions of the plate and may be larger than your printer's printable area. The finger tabs of the plate are 15mm in depth.

By ordering, you confirm that you have read the documentation here.